Need to identify behind dash components

Started by Laplaya, January 21, 2009, 11:19 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Laplaya

So I undid the six heater control assembly mounting screws and drew my dash out somewhat.
So the ??? I have are (at the moment) on the dash the switches I have are washer    next wiper   then ....gone
(although there appears to have been some add-ons to the wiper switch)I just have the hole and can find no "hangabouts as far as wiring....what if anything should live there. 

Then looking down from the top there is a relay looking thing that plugs in to the back of the dash panel just to port of the speedo cable . It has a vacant spade terminal on top ....anything?
Next to it was a paper covered affair that was broken off on one leg and as soon as I touched it the other leg broke off...anyone?
Port of that there is an empty double male spade....any ideas?

On a positive note ....I did find that the fuel tank selector switch was missing a wire and it was actually hanging right there ( HOORAY)
I was amazed when looking in to the lighting on this Winnie that almost every bulb in the running lights and dash was cooked.  7 dash lights 6 were cooked....All taillights and front signals etc were gone out... amazing...I did have on the starboard rear 2 of the plastic buttons that hold the bulb mounts in place were broken off so I drilled the plastic and ran brass screws in worked great.
Wow I feel better about growing older....don't need all those replacements ....YET

Thanks in advance for the help

AL

Aslan

It would be highly, highly helpful to post pictures.

ClydesdaleKevin

Yep...some digital pics are worth a million words and would help us identify some of those things for you.

Kev
Kev and Patti, the furry kids, our 1981 Ford F-100 Custom tow vehicle, and our 1995 Itasca Suncruiser Diesel Pusher.

DanielTBolger

wiper switch power is an add wire from the back of the fuse panel, the heater also and added wire to back of the fuse panel. The male spade was power to th VIR that made a jumper wire that went to the water temp gauge right of the speedometer. I think it also went to oil pressure. Not sure. I've done so much wire fixing on my 72 Winnie, things get little fuzzy to remember, but I hope this help you out.