Engine gaskets for 1971 413-1?

[Dodgy71]

Does anyone know if the Fel-Pro FS 8280 SH-1 is the correct complete engine gasket set for a 1971 413-1 engine? I'm asking because I see some potentially conflicting info regarding whether this set is for a 361 cubic inch vs. a 413-1. From the picture it seems to have the goofy waterpump housing and waterpump gaskets that I need most. If this is not correct, does anyone know the correct set, or better yet a current source for the waterpump housing to block (Dodge# 1737671) and waterpump housing to heads (Dodge# 1679150) for a 413-1?

[hemi354az]

Hey Dodgy,
Yes, Fel-Pro FS8280SH-1 is for the 413 Truck engine, I have that set of gaskets and confirmed that it is for the 413. It does NOT include the 413 Truck Intake Manifold Gasket, which has the small hole on one side for the water under carb heat. That Intake Manifold gasket (often called the "bathtub gasket") is FP #MS96001. Small hole side goes where the steel pipe runs from the Intake Manifold back to the Water Pump. It is stamped sheet metal and is for "one time use only", but they are pretty cheap.
But,if you want just the Water Pump gaskets:
Fel-Pro 13117 - WP Hsg to Cylinder Head
Fel-Pro 11731 - WP Hsg to Block
Fel-Pro 13116 - WP to WP Hsg  (this is the 5 bolt one)
Fel-Pro 35063 - Water Neck to WP Hsg (for the shrouded T-Stat)
These are probably cheapest at http://www.rockauto.com/. For instance the WP Hsg to Head gasket is .38¢ each. Get a few spares . . .
Gasket(s) ON ! Lou #120


ps: Did you check your Messages on this Winnie Website yet ?