318 Headers Fitment

[73braved18]

Hello, I searched the whole site here and am not 100% sure.


I found these on eBay
https://www.ebay.com/itm/Mopar-Chrysler-SB-318-340-360-Block-Hugger-Stainless-Steel-Exhaust-Header/291748170941?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649


Will they fit my Brave's 318?
I know there was some port size differences between car and truck blocks but would this header bolt on?
I have a big trip planned coming up and found both my manifolds cracked. They are very bad shape and not weldable.
I am pulling the 318 out this winter and putting in a Chevy LS motor in so I can't spend much. I would prefer to purchase manifolds but can not find any...well at least can't find the left side.
Thanks for any help guys!

[Berlin-Tioga]

Hi!
I can't tell you if they would fit or not. But when thinking about replacing the manifolds on my 440 with block huggers or such I recognised they would interfere with the original starter. In my case I need a mini-starter before going headers.

Good luck from germany,
ben

[73braved18]

Thanks for the reply. It looks like my starter may cause clearance problems too.

[yellowrecve]

What your looking at are shorty headers. They dump about where the stock manifold does. I'm putting a pair on a 440 and don't for see a problem.

[Berlin-Tioga]

@yellowrecve


Could you please let me know what exactly you bought?

@73braved18
sorry for highjacking your thread

Greets, ben

[yellowrecve]

I don't know where my paper work is. Paid about $150. Their stainless steel shorty headers. Lots on E-Bay. Bought them in March, have not had time to install. My cast iron manifolds are still good.
Les