Ballast Resistor Check

Started by LJ-TJ, April 25, 2011, 12:28 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

LJ-TJ

I have several ballast resistors sitting on the work bench. Are they good or are they bad that is the question. Is there a way to check to see if a ballAst resistor is any good or not.  Hm?

DaveVA78Chieftain

http://www.classicwinnebagos.com/forum/index.php?topic=3424.0
Half way down the page is Trouble Shooting section.  Steps 13 through 20 are for the Ballast Resistor.  The ohmage values (0.5 and 5.0) are also listed there.

Oh, resistance/voltage values for most of the components are listed there.

BTW - The resistor can read good cold but open when the engine compartment is heated to normal operating temps (i.e. intermittant problem).

Dave
[move][/move]


LJ-TJ

OK I cheated. I new I had seen it here some were. Thanks Dave.  D:oH!