Winnebago "eyebrow" decal application?

Started by JCMAC, July 09, 2013, 02:21 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

JCMAC

  I have just had my '72 D22C painted  :) and I have two Winne "eyebrow" decals to put over the front and rear windows.
  Problem: I need the installation instructions.  I think I can see how to do this, but don't want to screw it up.

Thanks,
John

Stripe

Get a good long straight edged plastic squeegee, and as you are applying the decal use it to keep bubbles from forming as you peel and stick. (This is assuming it's a 'peel n stick' decal of course). 

Any bubbles close to the edges can, usually, be squeegeed out to the edge, ones in the middle will be more difficult, I find that either cutting a slit or using a needle to put a hole in them, they are easy enough to press down.  If you have a particularly nasty bubble that is big, cutting an X in it and then pressing from the outer edges in usually works well.

Hope that helps a little bit.

Fredric
Fredric,
Captain of the Ground Ship "Aluminum Goose"
28' Holiday Rambler Imperial 28

LJ-TJ

You might want to consider a spray bottle with a water soap mix. Spray a mist on and then apply your decal.

JCMAC